SMARTRG 505N: Setup modem into Bridge Mode

  1. Open a web browser and navigate to the modem’s web interface by going to the following address:¬†http://192.168.1.1
  2. Click on the Advanced Configuration link. (Found in the top right corner)
  3. Enter the Admin username and password. (These should both be admin unless you’ve changed them)
  4. Click on the Advanced Setup link. (Found on the left side of the page)
  5. Click on the WAN Service link. (Found just below Advanced Setup)
  6. If there is anything present in the Wide Area Network (WAN) Service Setup table, check the Remove box(es) and then click the Remove button.
  7. Click the WAN Service link. (Found on the left side of the page)
  8. Click the Add button.
  9. Select the appropriate WAN Service Interface Configuration value from the drop down list.
  10. Click Next.
  11. Select Bridging as the WAN service type.
  12. Set the 802.1P Priority field to 0.
  13. Set the 802.1Q VLAN ID field to 35.
  14. Click Next.
  15. You should now find yourself at the WAN Setup – Summary page, click Apply/Save.
  16. Congratulations! Your Smart RG 505n modem is now bridged!